Maintenance & Service
Keeping a combined pool-spa system running the way it was handed over.
Equipment care after installation
Once a pool and spa are tied into one equipment pad, keeping both systems balanced is part of getting the value from the install. This page covers the maintenance side of ownership connected to our installation work — it is advisory information, not a separate priced service beyond the integration packages described on the services page.
A shared equipment pad means the pump, filter and heater schedule for the pool and the spa's control system both run from the same panel. Checking filter pressure, water chemistry and the spa's jet system together, rather than on separate routines, is designed to help catch an issue before it affects both sides.
We walk every client through this at handover, and point to the manufacturer's service schedule for the specific equipment installed, since warranty terms vary by brand.
Winnipeg's hard water and wide seasonal temperature swings both put extra demand on filters and heating elements, so keeping an eye on filter pressure through a hot stretch in July is as useful as checking it at the start of the season.
A short annual check of the heater element and filter housing, even outside a full service contract, tends to catch wear early enough that a small part swap avoids a bigger repair later in the season.
We keep a short written record of the equipment model and install date for every project, so if you call with a question months later we already have the specifics on hand rather than asking you to track them down.
This record also makes it easier to confirm, at a glance, whether an issue is likely tied to the pool side, the spa side, or the shared equipment pad, before we talk through next steps on the phone.
Who this information is for
null
This guidance is for clients who have had a pool-spa system installed or integrated by us and want to understand the upkeep that follows. It does not replace a dedicated pool-cleaning or chemical-service contract — we can point you to that kind of provider if you would like one, since it sits outside our installation scope.
A good rule of thumb is to look at the pool and spa together on the same day each week rather than checking each system separately on its own schedule — a change in one often shows up in the other first, since they share the same pad and, on the integrated builds, some of the same plumbing runs.
What this does not include
Scope limits, stated plainly
We do not run recurring chemical-dosing visits, pool cleaning rounds or equipment repair call-outs as a standalone service. What is included is the equipment and control-panel walkthrough at handover, and follow-up advice on the system we installed if something about its performance does not look right.
If a client wants ongoing chemical dosing or weekly cleaning, we are happy to recommend a local service provider who specializes in that recurring work, since it is a different skill set from the planning and coordination we do.
Coverage
null
Handover support applies to pool-spa systems we installed within the Pembina Highway, Winnipeg service area. View our location on the map.
If you are outside this service area but had a system installed by us before a move, email the details and we will do our best to point you to equivalent local support.
What backs this guidance
null
11 yrs
Installing and handing over pool-spa systems
1 panel
Shared equipment schedule for both systems
Noticed something off with a system we installed? Reach out and we'll take a look.